30kHz & 2.5kHZ Dr H Clark Duo-Wave ZAPPER with copper electrodes

30kHz & 2.5kHZ Dr H Clark Duo-Wave ZAPPER with copper electrodes

SKU: D-WZ
£70.50Price

30kHz & 2.5kHZ Dr H Clark Duo-Wave ZAPPER with copper electrodes - signal generator


The ZAPPER-RAPID is designed to destroy a wide range of parasites, pathogenic bacteria, fungal and mold colonies, and viruses in an active or dormant state. Removal takes place by electrocuting the membranes of microorganisms and parasites with low voltage.
Properly tuned frequency causes the membrane to resonate, and consequently causes its disintegration and neutralization.


This device is based on the activity of bio-resonance, but does not require tuning to the appropriate frequencies of particular pathogens, parasites, etc. The type of special square wave used in the device is a unique solution to eliminate a wide spectrum of pathogens.
ZAPPER should be operated according to the protocol. The protocol for using the device is available after purchasing the device on the manufacturer's website to download in PDF format.

ZAPPER-RAPID is made on original Dr Hulda Clark's diagram. Device is extremely easy to use, the small leflet is included to each order. According to Dr Hulda Clark protocol usage time of ZAPPER is 7 minutes x 3 times, with a break for 25 minutes betwen 7 minutes session. Device has low voltage bettery indicator, just replace the battery when the LED light goes off at the time of use.


Set includes:
- device Duo-Wave ZAPPER 30 kHz & 2.5 kHz -  Signal Generator
- 2x Copper Electrodes
- connecting wires - approximately 50cm of lenght, with alligator clips and 3.5mm jack plug
- 9 volt battery (PP3 type)


ZAPPER specification:
- amber & blue LED light with low voltage battery warning indicator
- switch ON/OFF/ON on front of device
- 3.5mm jack socket on front/side of device for connecting wire with copper electrodes
- 100% positive offset
- frequency output 30kHz (30000Hz) & 2.5kHz (2500Hz) +-2%
- square wave with 50% duty cycle
- input voltage 9 volt DC (PP3 type 9 volt battery operated only)
- output voltage 3 to 4.5 volt DC
- on circut board built-in NE555P CMOS chip
- current output 5-10mA (according to Dr Hulda Clark protocol !!!)

Switch position:
O – OFF
I – 30 kHz
II – 2.5 kHz

ZAPPER as bioresonance device is for general elimination all kinds of pathogens and is built on original Dr Hulda Clark diagram. Please use device according to the Clark's protocol and this information is widely available on the internet. Please note that this device does not cure anything, it is not a medical device. ZAPPER only is use for eliminating pathogens. This device is for scientific, cognitive and hobbyist applications.